To Start/Stop Recording In Sync With The Sound Source (Synchro-Recording) - Sony MZ-B10 Operating Instructions (primary manual) Operating Instructions Manual

To start/stop recording
in sync with the sound
source
(Synchro-recording)
During synchro-recording, the starting
and stopping of recording occurs are
synchronized with the sound source. This
simplifies digital recordings (e.g., from a
CD player) since the need to operate the
recorder or the sound source is
eliminated. Synchro-recording is only
possible with the optical cable connected.
REC MODE
1
Press REC MODE repeatedly until
"SP", "LP2", "LP4", or "MONO"
lights up in the display.
For details on the recording mode, see
"Long-time recording (MDLP)"
(page 18).
2
Press MENU/ENTER
3
Press . or > until "REC SET"
appears in the display, and then press
MENU/ENTER
4
Press . or > until "SYNC
REC" appears in the display, and then
press MENU/ENTER
MENU/ENTER
REC
. • REVIEW • AMS,
> • CUE • AMS
.
.
.
5
Press . or > until "SYNC ON"
appears in the display, and then press
MENU/ENTER
Synchro-recording indication
"SYNC" appears in the display.
"SYNC" doesn't appear if optical
cable is not connected to the LINE IN
(OPTICAL) jack on the recorder.
6
Press REC.
The recorder stands by for recording.
7
Play the source sound.
The recorder starts recording
automatically when it receives the
playing sound.
To stop recording
Press x • STOP.
z
When there is no sound from the player for
more than 3 seconds during synchro-recording,
the recorder goes into the standby mode
automatically (page 56). When the sound
comes from the player again, the recorder
resumes synchro-recording. If the recorder is
kept in the standby mode for 5 minutes or
longer, the recorder stops automatically.
.
23