While Editing; While Using Group Function - Sony MZ-M10 Hi-MD Music Transfer Version 1 for Mac (User Manual) Operating Instructions Manual

While editing

Symptom
"NOT ENOUGH
POWER TO EDIT"
appears and editing
cannot be done on a
1GB Hi-MD disc.
The lid does not open.
Editing cannot be done. • The power source has been disconnected or a power outage has
Non-audio data cannot
be erased.
Tracks cannot be
combined.
The disc cannot edit on
other component.

While using group function

Symptom
The group function does
not operate.
Cause/Remedy
• Editing is not possible when using a 1GB Hi-MD disc even when the
battery level indication shows enough power remaining while the
recorder is stopped or playing. This is because of a mechanism that
disables editing when the remaining battery power is estimated by
the recorder to be insufficient due to the high power consumption
required for 1GB Hi-MD disc editing.
, Connect the AC power adaptor to the recorder or insert a fully
charged rechargeable battery or a new alkaline dry battery.
• The recorder is saving the contents of an editing operation. The lid
will not open until "SYSTEM FILE WRITING" disappears from the
display.
occurred during editing.
, The editing done to that point is not saved to the disc. Do the
editing operation again.
• Non-audio data cannot be erased with the Erase function.
, Confirm the contents by connecting the recorder to your
computer. If it is okay to delete the contents, then perform the
Format function (page 55).
• This is due to the MiniDisc system limitations. When the tracks are
scattered and the length of each track is short*, you may not be able
to combine the tracks.
* Combining tracks of the following lengths may not be possible.
Hi-MD mode
LinearPCM: 9 seconds or less
Hi-SP: 8 seconds or less
Hi-LP: 32 seconds or less
MD mode
SP: 12 seconds or less
LP2/Monaural: 24 seconds or less
LP4: 48 seconds or less
• You cannot combine tracks recorded in different recording modes,
e.g., a track recorded in stereo and a track recorded in monaural; nor
can you combine a track recorded with digital connection and a track
recorded with analog connection.
• The component does not support Hi-MD.
, Edit on other component that support Hi-MD.
Cause/Remedy
• While using a disc without group setting, an attempt was made to
select some group-related menu.
, Use a disc with group setting.
73