While Editing - Sony Walkman MZ-N510 Operating Instructions Manual

Symptom
No sound comes
through the
headphones/
earphones.
The recorder skips
to several tracks
ahead or behind
when you press
. or > on
recorder.
The edited tracks
may exhibit sound
dropout during
search operations.
R-channel sound is
not output when
playing a track
recorded from a
cassette deck or an
amplifier, or when
listening a track
with connected
cassette deck or
through an
amplifier.

While Editing

Symptom
The lid does not
open.
Editing could not
be done.
The tracks that are
checked out from
your computer
cannot be erased.
60
Cause/Remedy
• The headphones/earphones plug is not firmly connected.
, Plug in the plug of the headphones/earphones firmly to the
remote control. Plug in the plug of the remote control firmly to
i.
• The plug is dirty.
, Clean the plug.
• The GROUP button has been pressed (
display).
, The recorder returns to normal if no operation has made for 5
seconds.
• This occurs due to the MiniDisc system limitation. The
fragmentation of data may cause sound dropout while searching
because the tracks are played in higher speed than normal
playback.
• R-channel sound is not output if connecting to a cassette deck or an
amplifier with a monaural cord.
, Make sure to use a stereo connecting cord. However, if the
connected equipment is a monaural specification, R-channel
sound will not be output even if connecting with stereo
connecting cord.
Cause/Remedy
• The power sources have been disconnected during recording or
editing, or the battery have been exhausted.
, Set the power sources again, or replace the exhausted battery
with new ones.
• The power sources have been disconnected or a power outage
occurred while editing.
, Editing result up to that point is not recorded on the disc. Do
the editing operation again
• This is due to the MiniDisc system limitations. To erase a track that
has been checked out from your computer, check it back in first,
and then erase it using the SonicStage software.
is flashing in the