While Editing - Sony Walkman MZ-N910 Operating Instructions Manual

Symptom
There is no R-
channel sound
output when
playing a track
recorded from a
cassette deck or
through an
amplifier, or when
listening to sound
from a cassette
deck or amplifier.

While Editing

Symptom
The lid does not
open.
Editing cannot be
done.
You cannot erase a
track checked out
from your
computer.
Track marks
cannot be erased.
The disc cannot
edit on other
component.
82
Cause/Remedy
• There is no R-channel output if the cassette deck or an amplifier is
connected with a monaural cord.
, Make sure to use a stereo connecting cord. If, however, the
connected equipment is monaural, there will be no R-channel
sound output even with a stereo connecting cord.
Cause/Remedy
• The power sources have been disconnected during recording or
editing, or the battery have been exhausted.
, Set the power sources again, or replace the exhausted battery
with new ones.
• The power source has been disconnected or a power outage has
occurred during editing.
, The editing done to that point is not saved to the disc. Do the
editing operation again.
• This is due to the MiniDisc system limitations. To erase a track that
has been checked out from your computer, check it back in first,
and then erase it using the SonicStage software.
• This is due to the MiniDisc system limitations. When the data of a
track is fragmented, the track mark of a fragment under 12 seconds
long (in SP stereo), 24 seconds long (in LP2 stereo mode or
monaural mode), or 48 seconds long (in LP4 stereo mode) cannot
be erased. You cannot combine tracks recorded in different
recording modes, e.g., a track recorded in stereo and a track
recorded in monaural; nor can you combine a track recorded with
digital connection and a track recorded with analog connection.
• The component does not support MDLP.
, Edit on other component that support MDLP.