Additional Information; Notes On Discs; Troubleshooting - Sony MCE-F11 Operating Instructions Manual

Additional Information

Additional Information

Notes on Discs

On handling discs
• To keep the disc clean, handle the disc by its edge. Do not
touch the surface.
• Do not stick paper or tape on the disc.
If there is glue (or a similar substance) on the disc, remove
the glue completely before using the disc.
• Do not expose the disc to direct sunlight or heat sources
such as hot air ducts, or leave it in a car parked in direct
sunlight as there can be considerable rise in temperature
inside the car.
• After playing, store the disc in its case.
On cleaning
• Before playing, clean the disc with a cleaning cloth. Wipe
the disc from the center out.
• Do not use solvents such as benzine, thinner, commercially
available cleaners or anti-static spray intended for vinyl
LPs.
20 EN

Troubleshooting

If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There's no sound.
Not this way
There's no picture.
The disc doesn't play.
The sound loses stereo effect.
The remote doesn't function.
The player doesn't play from the first track when playing
a VIDEO CD without PBC functions or an audio CD.
/Check that the player is connected securely.
/Make sure you operate the TV or the amplifier
correctly.
/Make sure you select the CD player position on
the amplifier.
/Check that the player is connected securely.
/Make sure you operate the TV correctly.
/Make sure you set the COLOR SYSTEM switch
correctly, according to your TV.
/There's no disc inside ("no dISC" appears).
Insert a disc.
/Insert the disc with the label side up on the disc
tray correctly.
/Clean the disc (see page 20).
/Moisture has condensed inside the player.
Remove the disc and leave the player turned on
for about an hour (see page 2).
/"MONO R" or "MONO L" appears in the front
panel display (see page 18).
/Remove the obstacles in the path of the remote
and the player.
/Point the remote at the remote sensor g on the
player.
/Replace all the batteries in the remote with new
ones if they are weak.
/Press PLAY MODE repeatedly until
"CONTINUE" appears in the front panel
display, then press ·.