Page 1
MCE-F88K SERVICE MANUAL E Model Model Name Using Similar Mechanism MCE-F11 CD Mechanism Type CDM14-5BD24 Base Unit Type BU-5BD24 Optical Pick-up Type KSS-213B/S-N SPECIFICATIONS VIDEO CD PLAYER...
THE PARTS LIST ARE CRITICAL TO SAFE OPERATION. 4-900-307-0s Malaysia, Singapore, Hong Kong model REPLACE THESE COMPONENTS WITH SONY PARTS 4-900-307-1s Thai model WHOSE PART NUMBERS APPEAR AS SHOWN IN THIS 4-900-307-3s Soudi Arabia model MANUAL OR IN SUPPLEMENTS PUBLISHED BY SONY.
SECTION 1 SERVICING NOTE HOW TO OPEN THE DISC TRAY WHEN POWER SWITCH NOTES ON HANDLING THE OPTICAL PICK-UP BLOCK TURNS OFF OR BASE UNIT Insert a tapering driver into the aperture of the unit bottom, and turn The laser diode in the optical pick-up block may suffer in the direction of arrow.
SECTION 2 GENERAL Front Panel Location of Parts and Controls 1 STANDBY LED 2 @/1 (Power) button 3 2 button 4 3 button 5 # button 6 KARAOKE PON button 7 Disc tray 8 A OPEN CLOSE button 9 EFFECT PICTURE button 10 EFFECT SOUND button 11 m button 12 M button...
Page 5
This section is extracted from instruction manual.
SECTION 3 DISASSEMBLY Note : Follow the disassembly procedure in the numerical order given. 3-1. FRONT PANEL • In order to remove the front panel block when the power supply does not turn on, rotate the cam with tapering driver as the figure shows, and the loading part will be moved.
SECTION 4 TEST MODE FLUORESCENT INDICATOR TUBE, LED ALL LIT, Buttons and Corresponding Button Numbers AND KEY CHECK MODE Button Button Number or Display 1. Short-circuit the SL501 of the VIDEO board. 2. Press the @/1 button to turn ON the power. 6c and LED lighting The whole fluorescent indicator tube and LED light up.
Page 14
VIDEO CD COLOR-BARS MODE On this mode, the data of the color-bars signal as a picture signal and the 1kHz sine wave signal as a sound signal are output by the mechanism control microcomputer (IC502) for video CD signal check. When measurement of the voltage and waveform on the VIDEO board, perform it in this mode.
SECTION 5 ELECTRICAL BLOCK CHECKING Note: E-F Balance Check 1. CD Block is basically designed to operate without adjustment. oscilloscope Therefore, check each item in order given. BD board 2. Use YEDS-18 disc (3-702-101-01) unless otherwise indicated. 3. Use an oscilloscope with more than 10MΩ impedance. TP (TE) 4.
Page 16
VIDEO SECTION Frequency adjustment frequency counter 1. Connect the frequency counter to check point of the VIDEO VIDEO board board. (DCLK) 2. Adjust CT503 of the VIDEO board so that the frequency counter – read 27MHz ± 80Hz at STOP condition. Adjustment Location : [ VIDEO BOARD ] –...
MCE-F88K 6-2. BLOCK DIAGRAMS – CD SECTION – OPTICAL PICK-UP BLOCK (KSS-213B/S-N) IC101 DIGITAL SERVO DETECTOR IC103 DIGITAL SIGNAL PRCESSOR RF AMP DIGITAL D OUT ADDRESS ERROR CORRECTOR GENERATOR DATA RF AC SERIAL/ D/A DATA RF EQ ADATA SUMMING REGISTER...
MCE-F88K • R CH: Same as L ch D-RAM IC507 IC506 • SIGNAL PATH – VIDEO SECTION – : CD : CHROMA 16 - 19 22 - 26 2 - 10 31 - 39 13 - 15 17 - 21...
Page 21
– VIDEO SECTION – WAVEFORMS THIS NOTE IS COMMON FOR PRINTED WIRING – CD SECTION – BOARDS AND SCHEMATIC DIAGRAMS. (In addition to this, the necessary note is printed in each block.) 4Vp-p 0.5Vp-p 1.3Vp-p For schematic diagrams. 10MHz 27MHz Note: IC502 qd XOUT IC509 1 XT1...
MCE-F88K 6-8. SCHEMATIC DIAGRAM – VIDEO (1/3) SECTION – • See page 26 for Waveforms. • See page 56 for IC Block Diagrams. • See page 58 for IC Pin Functions. (Page 24) (SEE PAGE 14) (Page 29) (Page 34)
MCE-F88K 6-9. SCHEMATIC DIAGRAM – VIDEO (2/3) SECTION – • See page 35 for Printed Wiring Board. • See page 60 for IC Pin Functions. (Page 27) (Page 27) (SEE PAGE 14) (Page 29) PIN FUNCTION (Page 29)
6-18. IC PIN FUNCTIONS • IC502 MPEG DECODER, MECHANISM CONTROL (M30620MC-303FP) Pin No. Pin Name Function SENSE Internal state (SENSE) monitor input (IC101) SENSE CLK Serial data reading clock output (IC101) DSP DATA Serial data output (IC101) DSP LATCH Lach output (IC101) DSP CLK Serial data clock output (IC101) TSENS...
Page 39
Pin No. Pin Name Function BUS XWRL Not used LO. BOOST Bass boost (H : OFF, L : ON) output AUDIO MUTE Audio mute output “L” : mute LOAD OUT TLAY in input LOAD IN TLAY out input INSW TLAY close sw input OUTSW TLAY open sw input MODEL 1...
Page 40
• IC505 CD DECODER, SYSTEM CONTROL (CL680T-D1) Pin No. Pin Name Function – Not used – Ground CD-BCK CD Decode bit clock CD-DATA CD Decode data CD-LRCK CD Decode Left or Right channel selection clock CD-C2PO CD Decode C2 error data –...
Page 41
Function Pin No. Pin Name Address data from CL680 to Microcode ROM/DRAM – Ground Address data from CL680 to Microcode ROM/DRAM VDD3 – +3.3V Power supply Address data from CL680 to Microcode ROM/DRAM Address data from CL680 to Microcode ROM/DRAM Address data from CL680 to Microcode ROM/DRAM –...
Page 42
Function Pin No. Pin Name PGIO0 Not used PGIO8 Not used PGIO2/VSYNC/CSYNC Vertical synchronized signal of video signal AVDD PLL – +3.3V Power supply – Not used – Not used – Not used AGND PLL – Ground – Ground – Not used PGIO3/HSYNC Not used...
SECTION 7 EXPLODED VIEWS NOTE: The components identified by • Hardware (# mark) list and accessories and packing • Items marked “*” are not stocked since they are mark 0 or dotted line with mark materials are given in the last of this parts list. seldom required for routine service.
7-4. BASE UNIT SECTION (BU-5BD24) M102 M101 The components identified by mark 0 or dotted line with mark 0 are critical for safety. Replace only with part number specified. Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark 0 151 8-848-379-31 OPTICAL PICK-UP KSS-213B/S-N...
SECTION 8 ELECTRICAL PARTS LIST Note: • Due to standardization, replacements in the parts list • SEMICONDUCTORS The components identified by In each case, u: µ , for example: may be different from the parts specified in the mark 0 or dotted line with mark uA...: µ...
Page 48
DISPLAY Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark R173 1-216-025-91 RES,CHIP 1/10W < IC > R175 1-216-025-91 RES,CHIP 1/10W R176 1-216-073-00 METAL CHIP 1/10W IC700 8-749-014-88 IC SPS-440-E R177 1-216-073-00 METAL CHIP 1/10W IC701 8-759-399-58 IC LC75725E R178 1-216-073-00 METAL CHIP 1/10W...