Sony MCE-F11 Operating Instructions Manual page 17

If you've made a mistake
Press CLEAR, then press the correct number button.
3
Press · to start Program Play.
To cancel Program Play
Press PLAY MODE repeatedly until "CONTINUE" appears in
the front panel display.
You can check the total playing time while
programming in Step 2 (Program Edit)
1 Press = or + until the track you want to program
appears in the front panel display.
The total playing time including the selected track
appears in the front panel display.
2 Press PLAY MODE to confirm your selection.
3 Repeat Steps 1 and 2 to program more tracks.
You can insert a pause as one step
During programming, press P to insert a pause. The
total playing time is reset to "0.00."
When playing a program which contains a pause, the
player pauses at the step in which a pause is
programmed, until you press P or ·. This might be
useful when you record a program on both sides of a
tape.
The program remains even after the Program Play
ends
When you press ·, you can play the same program
again.
Notes
If you play a VIDEO CD with PBC functions in Program
Play mode, you cannot use PBC functions (page 10).
If the total playing time exceeds 100 minutes, "– – . – –"
appears in the front panel display.
If you program more than 24 tracks, "FULL" appears in the
front panel display.
Playing CDs in Various Modes
Checking the track order
You can check your program before or after you start
playing.
Press CHECK.
Each time you press this button, the front panel display
shows the track number and the total playing time in
the programmed order. After the last track in the
program, the front panel display shows "End" and
returns to the original display.
Changing the track order
You can change your program before you start playing.
To
Press
Erase a track Z
CHECK until the track you don't
want appears in the display, then
press CLEAR.
Erase the last track in CLEAR. Each time you press this
the program Z
button, the last track is cleared.
Add tracks to the end
Number buttons of the tracks to be
of the program added.
Change the whole p (stop). Create a new program
program completely following the programming
procedure.
17 EN