Page 1
Audio and video connecting cord (1) jack (at 50 kilohms) Remote commander (remote) RMT-K750V/K550V (1) VIDEO OUT Phono 1Vp-p 75 ohms, unbalanced, Sony SUM-3 (NS) battery (2) jack sync negative, white Plug adaptor (1) (except model for China) peak S VIDEO OUT 4-pin mini Y:1Vp-p 75 ohms, unbalanced, Desing and specifications are subject to change without notice.
COMPONENTS IDENTIFIED BY MARK ! OR DOTTED LINE WITH MARK ! ON THE SCHEMATIC DIAGRAMS AND IN THE PARTS LIST ARE CRITICAL TO SAFE OPERATION. REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS PUBLISHED BY SONY.
SECTION 1 SERVICING NOTE HOW TO OPEN THE DISC TRAY WHEN POWER SWITCH SELF-DIAGNOSIS TURNS OFF This model has the self-diagnosis function for the video and audio decoder sections. Insert a screwdriver into the aperture of the unit bottom, and turn in Immediately after the power on, the self-diagnosis function searches the direction of arrow (to OUT direction).
SECTION 2 TEST MODE VIDEO CD COLOR-BARS MODE SERVO CHECK MODE On this mode, the data of the color-bars signal as a picture signal Connect the SL502 on the VIDEO board with solder. and the 1kHz sine wave signal as a sound signal are output by the Turn the power on.
Page 5
Lighting of All Fluorescent Indicator Tube Button Number (Displayed only Button Name Displays and Key Check Mode while a button is pressed.) NEXTˆ Figure 0E Connect SL501 on the VIDEO board with solder. §OPEN/CLOSE Figure 16 Turn the power on. RETURN Figure 30 All the Fluorescent Indicator tube displays light up.
SECTION 3 GENERAL Location of Parts and Controls Front Panel 4 5 6 7 Video CD !ª !• !¶ !§ !∞ !¢ !£ !™ !¡ !º !¡ STANDBY botton p botton !™ KEY CONTROL botton (K750 MODEL) P botton !£ KARAOKE STAR botton (K750 MODEL) ·...
SECTION 4 DISASSEMBLY Note: Follow the disassembly procedure in the numerical order given. 4-1. CABINET • In order to remove the front panel block when the power supply does not turn on, rotate the cam with screwdriver as the figure shows, and the disk table will be moved.
SECTION 5 ELECTRICAL ADJUSTMENTS CD SECTION Note : A clear RF signal waveform means that the shape “◊” can be clearly distinguished at the center of the waveform. Note : RF signal waveform CD Block is basically designed to operate without adjustment. Therefore, check each item in order given.
SECTION 6 DIAGRAMS Adjustment Location : VIDEO SECTION 6-1. CIRCUIT BOARDS LOCATION Frequency adjustment (NTSC) [ BD BOARD ] — SIDE A — Connect the frequenc y counter to c hec k point of the VIDEO BD board (RF) (VC) board.
MCE-K550/K750 6-12. IC BLOCK DIAGRAMS IC509 BU6257AFV-E2 IC510 CXD2721Q-1 IC701 LC75725E HSYNC PROTECTION CIRCUIT DATA INPUT VSYNC SHIFT REGISTER VIDEO RAM DATA CHARACTER HORIZONTAL WRITE CHARACTER COLOR CHARACTER SIZE ADDRESS ADDRESS DATA DATA DATA REGISTER REGISTER COUNTER 3-BIT 3-BIT 8-BIT...
6-13. IC PIN FUNCTION • IC504 SYSTEM CONTROL (M30610MC-103FP) Pin No. Pin Name Description SENS Internal State (SENS) monitor input from BD board SCLK SENS Serial data reading clock output to BD board DATA Serial data output to BD board Latch output to BD board Serial data clock output to BD board LDON...
Page 22
Pin No. Pin Name Description ECHO MUTE Echo mute input (H: Echo mute) (K750) (Not used:K550) KARAOKE KARAOKE mode select switch (H: KARAOKE, L: NORMAL (K750) (Not used:K550) MODEL1 K550 model select (H: K550) (Not used:K750) MODEL2 K750 model select (H: K750) (Not used:K550) 55 to 61 A15 to A9 —...
Page 23
• IC506 MPEG DISPLAY (CXD1854Q) Pin No. Pin Name Description Vss0 — Ground Connected to ground, or B signal input [MSB] Connected to ground, or B signal input Connected to ground, or B signal input Connected to ground, or B signal input Connected to ground, or B signal input Connected to ground, or B signal input Connected to ground, or B signal input...
Page 24
Pin No. Pin Name Description Cb/Cr (chroma) signal output, or R signal output [LSB] Cb/Cr (chroma) signal output, or R signal output Cb/Cr (chroma) signal output, or R signal output Cb/Cr (chroma) signal output, or R signal output Cb/Cr (chroma) signal output, or R signal output Cb/Cr (chroma) signal output, or R signal output Cb/Cr (chroma) signal output, or R signal output Cb/Cr (chroma) signal output, or R signal output [MSB]...
SECTION 8 ELECTRICAL PARTS LIST Note: • Due to standardization, replacements in the • RESIST ORS When indicating parts by reference number, par ts list ma y be diff erent fr om the par ts All resistors are in ohms. please include the board naame.
Page 36
VIDEO Ref. No. Part No. Description Remarks Ref. No. Part No. Description Remarks IC511 8-752-380-71 IC CXD1913Q R537 1-216-025-00 METAL GLAZE 1/10W IC512 8-759-269-92 IC SN74HCU04ANS-E20 (K550) IC513 8-759-925-90 IC SN74HC74ANS R538 1-216-073-00 METAL CHIP 1/10W R539 1-216-025-00 METAL GLAZE 1/10W <...
Page 37
VIDEO Ref. No. Part No. Description Remarks Ref. No. Part No. Description Remarks R593 1-216-025-00 METAL GLAZE 1/10W (K750) (K550) R638 1-259-199-11 CARBON 1/4W R594 1-216-025-00 METAL GLAZE 1/10W (K750) (K550) R639 1-259-199-11 CARBON 1/4W R596 1-216-025-00 METAL GLAZE 1/10W (K750) R597 1-216-025-00 METAL GLAZE...