Test Marking And Run Mode Operation - Panasonic LP-400 Series External Control Manual

1-1-2 Test marking and run mode operation

To irradiate the laser by the screen operation, operate the laser marker in test marking or run mode operation.
⿎ Test marking procedure
Test marking executes the laser radiation manually with the selected file.
1.
Select "TEST" of the marking mode in the
lower part of the screen.
2.
Turn ON the laser pumping switch on the
controller to start laser pumping.
3.
To start marking, click "START".
⿎ Run mode procedure
Run mode is an operation method to configure the settings of the laser marker by manual screen operation and to control
the marking start signal from the external devices such as switches or sensors connected to I/O terminal.
1.
Set the marking mode to "RUN".
2.
Turn ON the laser pumping switch on the
controller to start laser pumping.
3.
Click "START".
Under the RUN mode operation, the laser marker is in
the standby status for the marking start signal from I/O
terminal A4: TRIG. IN.
4.
Laser radiation starts by inputting the marking trigger on
the I/O terminal.
Connect a switch or sensor to A4: TRIG. IN. on the I/O terminal as
the input method of the marking start signal (trigger).
marking trigger
ME-LP400V-EX-6
Sensor for the
15