Panasonic LP-400 Series External Control Manual page 111

⿎ VEC logo conditions : CDC
Sets the marking condition of VEC (work shape converted for laser marker) logo file.
• Setting / Readout data of VEC logo condition
Sub
STX CDC
command
Sub command is "S" at the time of setting and "A" for response data at the time of readout.
• Readout request of VEC logo condition
STX CDC R
Name length
[byte]
Logo No.
Area No.
X scale
Y scale
X position
Y position
Rotation angle
Laser power
correction
Scan speed
correction
(Laser pulse cycle
correction)
(Only for LP-V
series)
Reference
• Use the CDD Command for the condition setting of DXF file. The common parameters with VEC and DXF files are
changed by either CDC/CDD command.
[Logo No.] [Area No.] [X scale] [Y scale] [X position]
[Y position] [Rotation angle] [Laser power correction]
[Scan speed correction]
[Laser pulse cycle correction]
51-byte (LP-V series),
48-byte (LP-400/LP-W series)
[Logo No.]
2-byte
Data
Content
2 "00"–"15"
1 "0"–"9", "A"–"F"
8
"0010.000"–"1000.000" [%]
8
8
"-300.000"–"+300.000" [mm]
8
7 "-180.00"–"+180.00" [°]
3 "000"–"200" [%]
3 "005"–"500" [%]
(3) "050"–"200" [%]
(Check sum) Delimiter
Specifies which area part is the marking position of
the concatenated marking on the flying object.
In case of marking static object, specify "0".
Specifies the origin coordinate of the logo.
The center of the rotation is the origin position of
logo file.
• The correction ratio is calculated using the value
set at the laser setting as 100%.
• With LP-400/LP-W series, nothing should be
input in Laser Pulse Cycle Correction.
ME-LP400V-EX-6
(Check
Delimiter
sum)
Remarks
111