KROHNE BM 70 A Remote Operation Instructions page 8

Attachment B
Process Variables
Status
Scan Device
-----------------------------------
Diagnostics and Test
Calibrate
-----------------------------------
Master reset
Entry Code
Service Code
-----------------------------------
Audit Trail
Drawing Notes ...
Help ...
-----------------------------------
Clear Offline Configuration
Compare Configurations
Configuration Properties
KROHNE Messtechnik GmbH & Co. KG · Ludwig-Krohne-Str. 5 ! D-47058 Duisburg
Tel.: 0203-301 0 ! Fax: 0203-301 389 · e-mail: krohne@krohne.de
Remote Operation Instructions BM 70 A/P, BM 700, BM 702 HART
BM 70 A/P /700 /702 Menu Tree AMS
• Level
• Distance
• Conversion
• Reflection
Opt
• Analog Output
• PV Percent of Range
• Relay State
Opt
Overview
• Primary variable out of limits
• Non-primary variable out of limits
• Primary variable analog output saturated
• Primary variable analog output fixed
• Cold start
• Configuration changed
• Field device malfunction
Critical
Hardware Failures
• CPU error
• ROM checksum error
• RAM read/write error
• Interrupt Controller error
• Timer error
• EEPROM Error
Informational
Warnings
• Signal low
• Signal too strong
• Poor spectrum
• Sweep low
• Empty Spectrum bad
• Measured value old
Designations:
Opt
– Optional, depends on device implementation;
– refer to the next page.
Configuration Errors
• Calibration data error
• Configuration error
Miscellaneous
• Tank bottom
• Measurement frozen
• Tank overfilled
• Relay in test mode
Opt
• Current set to error
• Relay set to error
Opt
KROHNE BM 70 A/P /700 /702 45f90b02
Runtime/Measuring Errors
• Signal down
• No measurement value
• VCO error
8/10