Sony 3-270-589-12 (1) Operating Instructions Manual page 104

METADATA [Metadata]: Metadata settings
ESSENCE MARK [>
EssnceMk]
HD VANC INPUT [> HD
VANC IN]: Make settings
related to recording of the
VANC data contained in
HDSDI input.
DATA ITEM OUT [> DATA ITEM]: Specify whether to include
the information from recorded VANC packets in data items
in the DATA ITEM section of MXF files.
SETUP BANK OPERATION [Setup Bank]: Settings related
to menu bank operations
Menu bank: This unit allows three different complete sets of menu settings to be saved in what are termed "menu banks"
numbered 1 to 3.
RECALL BANK 1 [> Recall 1]: Recall menu settings from
menu bank 1.
RECALL BANK 2 [> Recall 2] :Recall menu settings from
menu bank 2
RECALL BANK 3 [> Recall 3]: Recall menu settings from
menu bank 3.
SAVE BANK 1 [> Save 1]: Save current menu settings to
menu bank 1.
SAVE BANK 2 [> Save 2]: Save current menu settings to
menu bank 2.
SAVE BANK 3 [> Save 3]: Save current menu settings to
menu bank 3.
104
System Menu
SDI OUT [>> SDI out]: Select
whether to output
essence marks in the
VANC of HD/SDSDI
output.
SD VANC LINE [>> SDI
line]: When SDI OUT is
set to "ON", select the
line of SDSDI output in
which to output essence
marks.
HD VANC LINE [>> HD line]:
When SDI OUT is set to
"ON", select the line of
HDSDI output in which to
output essence marks.
LINE [>> Line]: Select the
line whose VANC you
want to record
DID [>> DID]: Select the DID
of the VANC you want to
record.
SDID [>> SDID]: Select the
SDID in the VANC you
want to record
Description
*ON [>>> ON]: Output.
OFF [>>> OFF]: Do not output.
12LINE [>>> 12 line] to 19LINE [>>> 19 line]: Select in the
range line 12 to line 19.
Factory default setting: *17LINE (line 17)
9LINE [>>> 9 line] to 20LINE [>>> 20 line]: Select in the
range line 9 to line 20.
Factory default setting:*17LINE (line 17)
*OFF [>>> OFF]: Do not record VANC from any line.
9LINE [>>> 9 LINE] to 20LINE [>>> 20 line]: Select from the
range line 1 to line 20.
Note
When this item is set to any setting other than OFF, VANC
packet information is saved in the DATA ITEM section of MXF
files.
00 [>>> 00] to FF [>>> FF]
Factory default setting: *00 [>>> 00]
00 [>>> 00] to FF [>>> FF]
Factory default setting: *00 [>>> 00]
OFF [>> OFF]: Do not include VANC packet information in
data items.
*ON [>> ON]: Include VANC packet information in data items.
Note
Set this menu item to OFF when you connect a nonlinear
editing system that does not support DATA ITEM.
Description
Operate with the following procedure.
(1) Select the bank you want to recall, then press the ,/OUT
button.
Message "RECALL OK?" appears.
(2) To recall, press the SET button.
To quit recalling, press the RESET button.
(3) To save the recalled bank, press the SET button once
again.
Operate with the following procedure.
(1) Select the bank you want to save, then press the ,/OUT
button.
Message "SAVE OK?" appears.
(2) To save, press the SET button.
To quit saving, press the RESET button.