Playback - Sony 3-270-589-12 (1) Operating Instructions Manual

• Perform a clip operation (lock or delete a clip)
• Make a network or FAM connection
• Eject the disc
• Change the recording format (change the setting of
OPERATIONAL FUNCTION >REC FORMAT in the
setup menu, or change the setting of AUDIO
CONTROL >REC MODE in the setup menu)
• Power the unit off
To turn the function off
Set OPERATIONAL FUNCTION >CLIP CONT. REC in
the setup menu to "OFF".

Playback

This section describes playback of video and audio on the
unit.
Before starting playback, make the following settings and
adjustments.
Selection of time data to display: Select with CNTR SEL
on page P1 of the function menu.
Selection of audio channels to monitor: Select with
MONI CH and MONI SEL on page P1 of the function
menu.
Volume adjustment of the monitor audio: Adjust with
the LEVEL knob.
Remote/local setting: Set the remote control switch. If
you set it to REMOTE, also set the setup menu item
INTERFACE SELECT >REMOTE I/F ("REMOTE"
and the connector used appear on the display).
Disc playback start position
Although this unit uses optical discs, it is designed to offer
the most convenient features of tape playback by VTRs.
One of these is the playback start position, which works in
the same way as tape, as described below.
After playback stop
The unit stops at the position where the STOP button was
pressed.
Press the PLAY button to resume playback at the stop
position.
After recording
The unit stops at the position where recording ended.
To play back a clip, press the PREV button to move to the
start frame of any clip or the previous REC START
1)
essence mark, or press the PREV button with the PLAY
button held down to move to any position.
1) The setting of OPERATIONAL FUNCTION >FIND MODE determines
whether the unit jumps to clips or to REC START essence marks.
When you play back clips recorded with the Clip Continuous Rec function
(see page 50), you should set this menu item to "REC START EM".
After disc insertion
The unit stops at the position of the disc when it was most
recently ejected.
Press the PLAY button to resume playback at the most
recent position.
The playback position is saved to the disc when the disc is
ejected, which allows playback to start at that position
whenever it is loaded into any XDCAM player.
51
Playback