Using The Pdbk-102 Mpeg-Ts Input/Output Board; Hdv Connection Example - Sony 3-270-589-12 (1) Operating Instructions Manual

Using the PDBK-102
MPEG-TS Input/Output
Board
With the PDBK-102 MPEG-TS Input/Output Board
installed in option slot 2 of this unit, you can make i.LINK
connections between this unit and video devices
complying with the HDV 1080i
devices" below), and between this unit and computers to
which HDV devices may be connected. These connections
can be used for input and output of MPEG-2 TS streams.
This allows you to input material shot by HDV camcorders
or the results of editing on a computer, and to record the
input on XDCAM discs. You can also output video and
audio from this unit to HDV devices.
1) HDV and
Company of Japan, Limited.

HDV Connection Example

The following example shows a connection between this
unit and an HDV camcorder.
PDW-F75
ACCESS
NETWORK
LOCAL
REMOTE
LEVEL
PHONES CH 1
i.LINK cable (not supplied)
i.LINK connector (4-pin)
Notes
• Install the PDBK-102 in option slot 2.
112

Using the PDBK-102 MPEG-TS Input/Output Board

1)
standard (called "HDV
are trademarks of Sony Corporation and Victor
F1
F2
F3
MARK1 VAR
MENU
F4 CHAPTER
SUB THUMB IN OUT
F5 EXPAND
SET RESET
CLIP NAIL JOG
PAGE DISPLAY
CLIP ESSENCE
MENU MARK
MARK2
PREV PLAY NEXT STOP REC SHUTTLE
KEY INHI
CH 2 CH 3 CH 4
VARIABLE
REC
PRESET
PB
SHIFT
TOP F REV F FWD END STANDBY
S400 connector (6-pin)
HDV camcorder
• The PDBK-103 and PDBK-104 cannot be used when the
PDBK-102 is installed.
EJECT