Sony 3-270-589-12 (1) Operating Instructions Manual page 102

AUDIO CONTROL [Audio]: Settings related to audio
control
DATA MODE [> Data mode]:
Specify whether to handle
digital audio signals as
non-audio signals during
recording.
LEVEL SELECT
[> Level Sel]
INT AUDIO SG [> Audio SG]: Select the operation of the
internal audio test signal generator. When you set A1
INPUT to A4 INPUT in the HOME page of the function
menu to "SG", the internal signal generator is activated
and outputs the selected test signal. You can record this
signal.
SHUTTLE MUTING [> Shtl muting]: Set the audio muting
conditions during shuttle playback.
EDIT POINT [> Edit Point]: Specify the type of editing for
audio signals.
DV OUT MODE [> DV out mod]: Select the audio output
mode of the S400 connector.
INTERFACE SELECT [Interface]: Settings related to
interfaces
D-SUB OUTPUT [> D-SUB Out]: Select the format of the
signal output from the MONITOR connector.
102
System Menu
CH1/CH2 IN [>> CH1/CH2]:
Specify for the input to
the DIGITAL AUDIO
(AES/EBU) 1/2
connectors.
CH3/CH4 IN [>> CH3/CH4]:
Specify for the input to
the DIGITAL AUDIO
(AES/EBU) 3/4
connectors.
REF LEVEL [>> REF Level]:
Specify the reference
level (headroom) for
audio signals recorded to
disc.
CH1 IN LEVEL [>> CH1
input]: Select the audio
level setting according to
the audio level of the
signal input to the AUDIO
INPUT 1/3 connector.
CH2 IN LEVEL [>> CH2
input]: Select the audio
level setting according to
the audio level of the
signal input to the AUDIO
INPUT 2/4 connector.
OUTPUT LEVEL [>> Out
Level]: Select the analog
audio output reference
level.
Description
*AUDIO [>>> Audio]: Handle as audio signals.
DATA [>>> Data]: Handle as non-audio signals.
*–20dB [>>> –20dB]
–18dB [>>> –18dB]
–16dB [>>> –16dB]
–12dB [>>> –12dB]
*+4dB [>>> +4dB]
0dB [>>> 0dB]
–3dB [>>> –3dB]
–6dB [>>> –6dB]
SILENCE [>> silence]: Silent signal
*1kHz SINE [>> 1kHz]: 1-kHz, –20 dB FS sine wave signal
*OFF [>> OFF]: Do not perform muting.
ON [>> FULL]: Perform muting.
CUT [>> Cut]: Cut editing (Discontinuity in audio signal may
result at the editing point, causing noise during playback.)
*FADE [>> Fade]: Fade in and fade out
IN OUT
4ch [>> 4ch]: 12 bit/32 kHz/4ch
*2ch [>> 2ch]: 16 bit/48 kHz/2ch
Description
XGA(SYSTEM) [>> XGA(SYS)]: Set to XGA monitor output
(according to system frequency).
*XGA(60Hz) [>> XGA(60Hz)]: Set to XGA monitor output
(fixed at 60 Hz).
YPbPr [>> YPbPr]: Y/R–Y/B–Y component video signals