ETC D22 Portable Quick Manual page 9

ETC Quick Guide
Desire Fixture Series
Plus 7
Strobe
D40XT, D40, D60, D60X– Studio Tungsten, and Studio Daylight
D22 - Studio Tungsten and Studio Daylight
DMX
Profile
Studio
Direct
D22, D40, D40XT, D60, D60X Fixtures
Adds seven additional color control channels to RGB, HSI, and HSIC input profile
settings. For example HSI with 'Plus 7' enabled becomes an 15-channel profile:
1 – Hue (coarse)
2 - Hue (fine)
3 – Saturation
4 – Intensity
5 – Strobe
6 – Fan Control
7 – n/a
8 – Plus 7 Control on/off
9 – Red
10 – Orange (white if
Lustr+)
11 – Amber
12 - Green
13 - Cyan
14 - Blue
15 -Indigo
Variable strobe control: 0% is no strobe. The fixture output will strobe more rapidly
as the strobe-channel value approaches 100%.
DMX Channel
Channels Assignments
1 - Intensity
2 - Strobe
3
3 - Fan Control
(D60 only)
1-Intensity
2-Strobe
3
3-Fan Control
(D60 only)
The desired color and intensity are achieved by using
the HSI or RGB channels
Placing channel eight at a value over 51% gives the
fixture a 15 channel profile.
Channels 9-15 represent the native colors of the
fixture and allow the operator to adjust individual
color channels to fine tune the color output.
Direct control of each individual color with a separate master
intensity channel. Color calibration of LEDs is not active in this
mode. The ten-channel profile will produce the highest
quality color cross fades.
Page 9 of 12
Notes
Electronic Theatre Controls, Inc.