Saunders CRANE I-VUE Quick Start Manual page 7

Saunders® I-VUE
Tools Required:
Philips or Flat head screwdriver
8 mm open ended spanner
Spanner to suit air fittings
Low strength threadlock adhesive (recommended)
Thread sealing compound for pneumatic fittings (if required)
2) Unscrew sensor electronics module from
sensor mounting base via the 3 screws
Basic Installation Guide
1) Screw magnetic target into actuator indicator. Use
threadlocking adhesive (if required)
3) Mount sensor mounting base to actuator via
the 2 screws
Rev 1.00
For actuators that require a mounting
kit. Please contact Saunders for the
relevant installation procedure
www.saundersI-VUE.com
www.cranechempharma.com
7