Table of Contents
Advertisement
Aborting a Process
Same as switching to next Process, push and release Button 1 or mo-
mentarily latch TB1.
MP2+ Multiple Program Process
Temperature Controller w/
TM02 Multifunctional Timer Control
Switching to another Program
Switching to another program can only be accomplished by entering the
Initial Programming Menu
Switching to Next Programmed Process
Timed processes
Nothing is required. The MP2
next programmed Process after timing out.
NOTE: If the last Process of a program is timed, it will proceed either to the
"READY" position or to the First Process. By selecting the First Process in
the LOOPING Mode menu, the MP2
program loop (see page 7, LOOPING Mode).
Untimed (Manual) Processes
An untimed Process will remain in the Process indefinitely until Button 1 is
pushed and released or TB1 is momentarily latched. Pushing and releas-
ing Button 1 or the momentary latching of the TB1 will cause the MP2
System to proceed to the next Process. If the last Process of a program
is untimed, pushing and releasing Button 1 or the momentary latching
of TB1 will cause the MP2
start position. Multiple contacts used to switch untimed Processes are to
be wired in parallel.
Aborting a Timed Process
Push and release Button 1 or momentarily latch TB1 twice within a 10 sec-
ond period or latch and hold continuously for 10 seconds.
Connecting Indicator Relays
Process 1 thru 8 indicators use a corresponding pair of terminals, labeled
Relay (1 - 8), on the TM02. The Program indicator uses a corresponding
terminal labeled Relay 9. Wire each indicator (LED, relay coil, etc.) 24
VDC 2 W maximum directly to the desired corresponding terminal. See
figure A, page 18. Note polarity where applicable.
© 2006 Maxitrol Company, All Rights Reserved
and selecting "Program Set #".
+
System will immediately proceed to the
+
can be programmed into a continuous
+
system to proceed to the selected program
17
Operation
+
Advertisement
Table of Contents
