Operation; Mp2+ Multiple Program Process - Maxitrol Selectra MP2+ User & Programming Manual

Monitor (Global Setting)
1
Scroll
2 Monitor set
3 Either Monitor Mode On or Off will flash 3 times to confirm.
Looping (Global Setting)
1 Scroll
2 Scroll
3 **Stored** will flash 4 times to confirm entry.
F/C Mode (Global Setting)
1 Scroll
2 F/C MODE, scroll
3 **Stored** will flash 4 times to confirm entry.
NOTE: Changing between F and C will cause the MP2+ system to reset to
factory defaults.
Software Version (Global Setting)
1
Scroll
2 Software Version information will appear.

MP2+ Multiple Program Process

Temperature Controller
Switching to another Program
Switching to another program can only be accomplished by entering the
Initial Programming Menu
Switching to Next Programmed Process
Push and release Button 1 on dial face (see page 11) or momentarily
latch (make) a set of contacts wired to the TB1 terminal (i.e. typically ac-
complished by a momentary ON (normally open) switch) to proceed to the
next Process. Pushing and releasing Button 1 or momentary latching of
TB1 during the last Process of a program will cause the MP2+ System to
return to Process 1. Multiple contacts used to switch Processes are to be
wired in parallel.
© 2006 Maxitrol Company, All Rights Reserved
to Monitor, press
On or Off, press
to Looping Mode, press
to READY or FIRST PROCESS, press
to F/C Mode, press
to either Fahrenheit or Celsius, press
to Menu Software Version, press
and selecting "Program Set #".
Programming the MP2+
.
ENT
.
ENT
.
ENT
.
ENT
16
.
ENT
ENT
.
ENT

Operation

.