Trouble Shooting Problems - XP Metal Detectors Goldmaxx Power Instruction Manual

T R O U B L E
P R O B L E M S
P
ROBLEMES
You hear a
series of beeps
with a regular
interval.
You can't
start your
detector.
You notice
excessive
false signals
without
reasons
You notice
false signals
when the
search head
knocks the
ground.
The detector
beeps on
pottery & "hot
rocks" (not
coke)
If the problem persists, contact your retailer for advice.
S H O O T I N G
C
AUSES
Low batteries.
Wrong polarity
Batteries are badly inserted or
upside down.
A 6.35 plug is inserted in the
headphone plug.
The loudspeaker is defective.
The sensitivity is too high.
The search coil connector is badly
fitted to the control box
Your headphone cable is defective.
You are passing through an area
with a lot of interference (high
voltage cable,
transformer, electric fence).
You are close to other metal
detectors.
GROUND control is too low.
GROUND control is too low.
Check if you have correctly inserted
the batteries in each pack. One
battery might be in the wrong way
Check the way the batteries have
been inserted in the 2 battery
holders (refer to chapter 4)
Plug in headphones to check.
Re fit it without forcing.
Change the headphones.
Lower the sensitivity or get away
electric
Change frequency using the FREQ.
Turn the GROUND control slightly to
the right until false signals stop.
Turn the GROUND control slightly to
the right until false signals stop.
21
9
S
OLUTIONS
Change the batteries .
around.
Remove it.
Lower it.
from this area.
SHIFT (refer to chap.5)