Front Brake Pad Check - Hyundai GENESIS COUPE BK 2010 Manual

4. If wear exceeds the limit, replace the discs and pad assembly left and right of the vehicle.

Front Brake Pad Check

1. Check the pad wear. Measure the pad thickness and replace it, if it is less than the specified value.
Pad thickness
General caliper type
Standard value : 11mm (0.43in)
Service limit : 2.0mm (0.0787in)
Brembo caliper type
Standard value : 8.5mm (0.33in)
Service limit : 2.0mm (0.0787in)
2. Check that grease is applied, to sliding contact points and the pad and backing metal for damage.
Front Brake Disc Runout Check
1. Place a dial gauge about 5mm (0.2 in.) from the outer circumference of the brake disc, and measure the runout of
the disc.
Brake disc runout
Limit : 0.035mm (0.00137in.) or less (new one)
2. If the run out of the brake disc exceeds the limit specification, replace the disc, and then measure the run out again.
3. If the run out does not exceed the limit specification, install the brake disc after turning it and then check the run out
of the brake disc again.
4. If the run out cannot be corrected by changing the position of the brake disc, replace the brake disc.
Installation
1. Installation is the reverse of removal.
2. Use a SST (09581-11000) when installing the brake caliper assembly.
3. After installation, bleed the brake system. (Refer to Brake system bleeding)
Brake System > Brake System > Rear Disc Brake > Components and Components