Component Location - Hyundai GENESIS COUPE BK 2010 Manual

Verification of Vehicle Repair
After a repair, it is essential to verify that the fault has been corrected.
1. Connect scan tool and select "Diagnostic Trouble Codes(DTC)" mode.
2. Using a scan tool, clear the DTC.
3. Operate the vehicle within DTC Enable conditions in General information.
4. Are any DTC present ?
▶ Go to the applicable troubleshooting procedure.
▶ System is performing to specification at this time.
Restraint > SRSCM > B1738 P-SIS front – Driver Wrong ID

Component Location

Pressure-Side Impact Sensor and Side Impact Sensor are installed in the left and the right side of front door and in
the lower of B-pillar respectively.
The Pressure-Side Impact Sensor senses an impact based on an acceleration at crashing. Unlike the conventional
acceleration sensor, the Pressure Sensor senses an air pressure by a distorted door at crashing and measures an
impact.
The SCM detects the impact signals of the Pressure-Side Impact Sensor and Rear Side Impact Sensor and compares
with signals of the safe sensor inside. If the signals of all sensors are judged as a collision, the side-airbag and the
curtain-airbag would be unfolded.