General Description - Hyundai GENESIS COUPE BK 2010 Manual

Verification of Vehicle Repair
After a repair, it is essential to verify that the fault has been corrected.
1. Connect scan tool and select "Diagnostic Trouble Codes(DTC)" mode.
2. Using a scan tool, clear the DTC.
3. Operate the vehicle within DTC Enable conditions in General information.
4. Are any DTC present ?
▶ Go to the applicable troubleshooting procedure.
▶ System is performing to specification at this time.
Restraint > SRSCM > B2500 Warning lamp Failure

General Description

Air bag warning lamp is located at cluster
When key is in 'ignition on' position, SRSCM performs diagnosis of overall air bag system.If there's no fault, air bag.
Warning lamp in cluster flickers for a whlie and then goes out.
SRSCM measures voltage of out terminal of warning lamp to check if warnning lamp is operated in accordance with
signal SRSCM sends.
DTC Description