Verification of Vehicle Repair
After a repair, it is essential to verify that the fault has been corrected.
1. Connect scantool and selet "Diagnostic Trouble Codes(DTCs)" mode and then clear DTC.
2. Operate the vehicle and monitor the DTC on the scantool.
3. Are any DTCs present?
▶ Go to the applicable troubleshooting procedure.
▶ System is performing to specification at this time.
Body Electrical System > Smart key System > Smart key > Repair procedures
Smart Key
Smart Key Code Saving
1. Connect the DLC cable of GDS to the data link connector (16 pins) in driver side crash pad lower panel, turn the
power on GDS.
2. Select the vehicle model and then do "Smart key code saving".