Hyundai GENESIS COUPE BK 2010 Manual page 2267

Monitor Scantool Data
1. Ignition "OFF", connect scantool.
2. Ignition "ON"& Engine "OFF", select "Diagnostic Trouble Codes(DTC)" mode.
3. Monitor diagnostic trouble code and present of trouble code.
4. Using a scan tool, clear the DTC.
5. Is DTC present problem ?
▶ Go to "W/Harness Inspection" procedure.
▶ Displaying nothing(no DTC) or DTC with label "H"(historical) shows that Fault is intermittent
caused by poor contact in the part's and/or SRSCM connector or was repaired and SRSCM
memory was not cleared.
Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination,
deterioration, or damage.
▶ Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.