Agri-Fab 45-2142 Owner's Manual page 5

IMPORTANT: Do Not asssemble handle tube to same
side of crossover tube as shaft support plate.
9. Place the long handle tube onto the crossover
tube on the side opposite from the shaft support
plate. Fasten with the 1/4" hex bolt, flat washer
and hex lock nut removed in the previous step.
See figures 4 and 5. Do not tighten at this time.
10. Assemble two handle braces to the inside of the
hopper frame, one on each side, using two 1/4" x
1-1/2" hex bolts and two 1/4" lock nuts. See figure
5. Do not tighten at this time.
11. Assemble the other end of the two handle braces
to the long handle tube using a 1/4" x 1-1/2" hex
bolt and 1/4" lock nut. Do not tighten at this
time.See figure 5.
12. Tighten all hex lock nuts and bolts in same
sequence as assembled in steps 9 through 11.
See figure 5.
HANDLE TUBE (LONG)
HEX BOLT
1/4" x 1-1/2"
1/4"
LOCK
NUT
FLAT WASHER
1/4" HEX
LOCKNUT
FIGURE 5
HITCH
BRACE
HEX BOLT
1/4" x 1-1/2"
1/4" HEX
BOLT
CROSSOVER
TUBE
SHAFT
SUPPORT
PLATE
13. Assemble the leg stand tube to the handle tube
(long) using two 1/4" x 1-1/2" hex bolts. Secure
tightly with two 1/4" hex lock nuts. See figure 6.
14. Place a vinyl cap over the end of the leg stand tube.
See figure 6.
HANDLE TUBE (LONG)
1/4"
LOCK
NUT
VINYL CAP
FIGURE 6
15. Assemble the flow control link (end with small hole)
to the flow control arm using a 1/4" x 3/4" hex bolt,
a nylon washer and a 1/4" hex lock nut as shown in
figure 7. Tighten carefully. The flow control link
should not be loose but should pivot with no more
than slight resistance.
FLOW CONTROL
LINK
1/4" x 3/4"
HEX BOLT
SMALLEST
HOLE
NYLON
WASHER
FIGURE 7
5
1/4" x 1-1/2"
HEX BOLTS
LEG STAND TUBE
FLOW
CONTROL
1/4" HEX
LOCK NUT
ARM