Pa Circuit; Extension Speaker - Honeywell Accenta Engineer's Manual

PA Circuit

PA Circuit
It is recommended that no more than 10 Normally Closed type personal attack buttons may be wired in series
and then connected to the PA circuit.
Operational in Unset and Set, the PA circuit will cause a full alarm condition when activated. PA is
indicated on the control panel or RKP.
PA buttons may be fitted near the front door or in a bedroom.

Extension Speaker

Extension speakers may be connected to the loudspeaker terminals to produce high volume alarm tones and
low volume entry / exit / fault tones.
Up to two 16 ohm extension speakers may be wired across the speaker terminals. Mounted in convenient
positions within the installation the extension speakers will reproduce all of the alarm tones generated by the
control panel.
A control marked VOLUME may be used to adjust the low volume entry/exit tones to suit environmental
conditions.
anel
Board
J2
1 2 3 4 5 6
Button
Button
Figure 9. PA Circuit
Panel
13V SPEAKER
F2
1A
+
T
TROBE
16 Ohms
Figure 10. Extension Speaker Wiring
Accenta/Optima Engineer's Manual
A
TAM +13V 0V
7 8
-
+
anic
anic
Board
F3
J6
ET
A D B
+ve
BELL
CB
1A
+
Extension Speaker
8