JUNO JB136D8 User Manual page 32

32
Problem
The display does not show
the time during the off sta‐
tus.
It takes too long to cook the
dishes or they cook too
quickly.
Steam and condensation
settle on the food and in the
cavity of the oven.
The display shows "C3".
The display shows "F102".
The display shows an error
code that is not in this table.
The appliance is activated
and does not heat up. The
fan does not operate. The
display shows "Demo".
Service data
If you cannot find a solution to the problem
yourself, contact your dealer or an
Authorised Service Centre.
The necessary data for the service centre
is on the rating plate. The rating plate is
Possible cause
The display is deactivated.
The temperature is too low
or too high.
You left the dish in the oven
for too long.
The cleaning function does
not operate. You did not fully
close the door, or the door
lock is defective.
• You did not fully close
the door.
• The door lock is defec‐
tive.
There is an electrical fault.
The demo mode is activa‐
ted.
on the front frame of the appliance cavity.
Do not remove the rating plate from the
appliance cavity.
Remedy
Touch and at the
same time to activate the
display again.
Adjust the temperature if
necessary. Follow the ad‐
vice in the user manual.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
Fully close the door.
• Fully close the door.
• Deactivate the oven with
the house fuse or the
safety switch in the fuse
box and activate it again.
• If the display shows
"F102" again, contact the
Customer Care Depart‐
ment.
• Deactivate the oven with
the house fuse or the
safety switch in the fuse
box and activate it again.
• If the display shows the
error code again, contact
the Customer Care De‐
partment.
Refer to "Using the settings
menu" in "Additional func‐
tions" chapter.