Table of Contents
Advertisement
3
Press ENTER/YES.
One of the following messages appears,
depending on the last edit.
Editing done
Labelling a track or
an MD
Erasing labelled
titles
Erasing a single
track
Erasing all tracks
Erasing a portion
of a track
Moving a track
Dividing a track
Combining tracks
4
Press ENTER/YES again.
"MD Complete!!" appears for a few seconds
and the contents of the MD are restored to
the condition before the edit.
To cancel Undo
Press MENU/NO before completing the
procedure.
Message
"MD Name Undo?"
"MD Erase Undo?"
"MD Move Undo?"
"MD Divide Undo?"
"MD Combine Undo?"
Optional Components
Connecting a digital
component
Connect the digital component using audio cords
(not supplied) and an optical cable (square optical
connector, not supplied). The digital audio signal
from the connected component is digitally
recorded to the MD.
The analogue connection is for monitoring the
audio, and the digital connection is for recording.
If there is no analogue connection, no sound will
be produced from the speaker. The digital audio
signal from the connected component is recorded
to the MD. However, if the digital component is
not connected to the DIGITAL OPTICAL AUX
IN, the audio connected to the AUX IN (analogue)
will be recorded as an analogue signal.
Also refer to the operating instructions for each
component.
continued
39
Advertisement
Table of Contents
