Table of Contents
Advertisement
Recording a tape on an MD
(continued)
1
Insert a recordable MD.
With the arrow pointing toward the deck.
With the label side up, and the shutter on
the righthand side.
2
Press A on the tape deck to open the
cassette tray and insert a tape.
With the side you want to play facing up
Press A again to close the cassette tray.
3
Turn FUNCTION until "TAPE"
appears.
4
Press z REC on the MD deck.
The MD deck stands by for recording.
>>> appears for the front side, and <<< for
the reverse side. To play the side not
indicated, press s on the tape deck and
remove the tape to reverse the tape side, then
do steps 3 and 4 again.
14
Tape playback side
5
Press H on the MD deck.
Recording starts.
6
Press H on the tape deck.
To stop recording
Press s on the MD deck.
Tips
• If you use a partially recorded MD, recording starts
after the recorded tracks. To erase the recorded
contents, see "Erasing recordings" on page 31.
• If the Smart Space function is on and there is no
sound input for about 3 seconds or more (but less
than 30 seconds) while recording, the MD deck
replaces this silence with a blank of about 3 seconds
and continues recording. However, this function
may not activate if there is noise.
Note
If the MD is record protected, "C11" and "Protected"
appear alternately and the MD cannot be recorded.
Remove the MD, then slide the record protection tab
to the closed position (see page 11).
Advertisement
Table of Contents
