Table of Contents
Advertisement
4
Set the time to start recording.
Press . or > repeatedly to set the hour,
then press ENTER/YES.
The minute indication flashes.
Press . or > repeatedly to set the
minute, then press ENTER/YES.
The hour indication flashes again.
5
Set the time to stop recording following
the procedure in step 4.
"OFF TIME NG" appears if the start time
and the stop time settings are the same.
Change the stop time.
6
Press . or > repeatedly to select
the recording source, then press
ENTER/YES.
The indication changes as follows:
When recording on an MD
t TUNER c MD
r
TUNER c MD (M)*
r
AUX** c MD
r
AUX c MD (M)
* When you record onto an MD in monaural
format.
** You can select the connected component for
recording source. Set the timer on both
systems to the same time.
When you press ENTER/YES, the start time,
stop time and other setting contents appear in
turn, then the original display returns.
"REC" lights up.
7
Insert a recordable MD.
If you use a partially recorded MD, recording
starts after the recorded tracks.
8
Press ?/1 to turn off the system.
To cancel the procedure
Press CLOCK/TIMER SET.
To change the setting
Start over from step 1.
To check the setting/activate
the timer
Press CLOCK/TIMER SELECT and press .
or > repeatedly until "SEL MD REC" appears.
Then press ENTER/YES.
It is not necessary to set the start and stop times
every time.
To cancel the timer
Press CLOCK/TIMER SELECT and press .
or > repeatedly until "TIMER OFF" appears.
Then press ENTER/YES.
Tips
• The system automatically turns on about 30 seconds
before the start time and prepares for timer-
recording. Recording starts as soon as the system is
ready, so recording may start earlier than the preset
time.
• When you record from the radio, the station name
(or frequency when the station is not labelled), the
start time and the stop time are automatically
recorded on the MD.
Notes
• You cannot activate Daily Timer and the recording
timer at the same time.
• Do not operate the system from the time the system
turns on until the recording starts (about 30 seconds
before the preset time).
• If the system is on about 30 seconds before the
preset time, the timer-recording will not be
activated.
• The Smart Space and Level Synchro Recording
functions do not operate.
• The volume is reduced to minimum during
recording.
21
Advertisement
Table of Contents
