Getting Started; Preparing The Wireless Remote Commander; How To Load The Batteries - Sony DVX-100 Operating Instructions Manual

Getting
Started
This section describes how to prepare
the wired remote commander, the
wireless remote commander, the unit,
and how to change the transmitting
frequency.
12
Preparing the wireless
remote commander

How to load the batteries

1
Press and slide the battery cover to open.
2
Insert two AA (R6) alkaline batteries.
Caution
Be careful to match the + and – ends of the batteries to the
marking inside the compartment.
3
Replace the cover.
Notes
• Do not hold the battery with metallic tweezers, otherwise a
short-circuit may occur.
• Do not leave the remote commander in an extremely hot or
humid place.
• Do not drop any foreign object into the remote commander,
particularly when replacing the batteries.
• If you do not intend to use the remote commander for an
extended period of time, remove the batteries to avoid possible
damage from battery leakage and corrosion.
• When the batteries wear out, dispose of them in a safe manner
that complies with all applicable laws.