US Model Canadian Model Ver 1.0 2001.09 AEP Model UK Model E Model Chinese Model • DVX-100 is composed of following units. DVD changer FM modulator (RF unit) Wired remote commander (RM-X130) Wireless remote commander (RM-X120) Remote control sensor L 13942296513...
Page 2
AND IN THE PARTS LIST ARE CRITICAL TO SAFE DE FONCTIONNEMENT. NE REMPLACER CES COM- OPERATION. REPLACE THESE COMPONENTS WITH POSANTS QUE PAR DES PIÈCES SONY DONT LES SONY PARTS WHOSE PART NUMBERS APPEAR AS NUMÉROS SONT DONNÉS DANS CE MANUEL OU SHOWN IN THIS MANUAL OR IN SUPPLEMENTS PUB- DANS LES SUPPLÉMENTS PUBLIÉS PAR SONY.
DVX-100 SECTION 1 SERVICING NOTES 3 7 63 1515 0 TEST DISC DISC MAGAZINE GETTING OUT PROCEDURE This set can playback a CD-R, CD-RW for audio use and DVD. ON THE POWER SUPPLY IS OFF When test this set, use the following test disc.
DVX-100 3 7 63 1515 0 This Unit Can Play the Following Discs DVD VIDEOs Video CDs Audio CDs Disc logo Contents Audio + Video Audio + Video Audio The “DVD VIDEO” logo is a trademark. Region code of DVDs you can play on this unit A DVD disc contains both audio and visual data.
DVX-100 3 7 63 1515 0 This Unit Can Play the Following Discs Note on PBC (Playback Control) (Video CDs) This player conforms to Ver. 1.1 and Ver. 2.0 of Video CD standards. You can enjoy two kinds of playback according to the disc type.
DVX-100 SECTION 2 This section is extracted from instruction manual. 3 7 63 1515 0 GENERAL Location of controls Wireless remote commander 1 MENU button 30, 33, 34 Press MENU to display the recorded DVD and Video CD menu.
Page 8
DVX-100 3 7 63 1515 0 Location of controls Wired remote commander DISC Window display 3 DISC (–/+) button 16 1 B/X button 14, 16 (equivalent to w; on the wireless remote commander) — For starting up the unit Press B/X* for starting up the unit.
DVX-100 3 7 6 3 1 5 1 5 0 Precauciones Diagrama de conexión (2) To parking brake swich cord a un punto metálico del automóvil •Esta unidad está diseñada para funcionar Al cable de conmutación del freno de estacionamiento...
DVX-100 SECTION 3 DISASSEMBLY 3 7 63 1515 0 • This set can be disassembled in the order shown below. 3-1. DISASSEMBLY FLOW Note 1: The process described in can be performed in any order. Note 2: Without completing the process described in , the next process can not be performed.
DVX-100 3 7 63 1515 0 3-8. DC MOTOR ASSY (ELEVATOR) (M1) 1 special washer mount-M 2 B gear 3 special washer mount-M 5 two screws (M2 × 2.5) 4 A gear pressure welding cord (5P-100 mm) 6 Remove two elevator motor lead wire solders of pressure welding cord.
DVX-100 SECTION 4 ASSEMBLY 3 7 63 1515 0 4-1. ADJUSTING PHASE OF A SLIDE PLATE, B SLIDE PLATE, C SLIDE PLATE AND D SLIDE PLATE. • When installing the elevator section, slide A slide plate and B slide plate, C slide plate and D slide plate respectively, install the axis of the elevator chassis assy as shown in the figure.
DVX-100 6-7. SCHEMATIC DIAGRAMS – SERVO Section – 3 7 6 3 1 5 1 5 0 (Page 30) 1 3 9 4 2 2 9 6 5 1 3 (Page 30) w w w u 1 6 3 The components identified by mark 0 or dotted Les composants identifiés par une marque 0 sont...
DVX-100 3 7 63 1515 0 6-20. IC PIN FUNCTION DESCRIPTION • MAIN BOARD IC301 µPD78F0034AGK-9/7402AA (MECHANISM CONTROLLER) Pin No. Pin Name Description Loading motor drive signal output for loading out direction LD– Loading motor drive signal output for loading in direction...
Page 43
DVX-100 3 7 63 1515 0 • MPEG BOARD IC801 MB91101APFV-G-BND (CPU) Pin No. Pin Name Description CSIL Not used (open) CSIH Not used (open) /DWI Not used (open) — VCC3 Power supply terminal (+3.3V) System clock signal output...
Page 44
DVX-100 3 7 63 1515 0 Pin No. Pin Name Description CS0L Column address strobe signal output CS0H Column address strobe signal output NDW0 Write enable signal output RAS1 Not used (open) L 13942296513 u163 http://www.xiaoyu163.com...
DVX-100 SECTION 7 EXPLODED VIEWS 3 7 63 1515 0 NOTE: • Items marked “*” are not stocked since they • -XX and -X mean standardized parts, so they The components identified by mark 0 or dotted line with mark may have some difference from the original are seldom required for routine service.
DVX-100 3 7 63 1515 0 7-7. MECHANISM DECK (DVD CHASSIS SECTION) L 13942296513 elevator chassis section The components identified by Les composants identifiés par une mark 0 or dotted line with marque 0 sont critiques pour la mark 0 are critical for safety.
DVX-100 SECTION 8 LOAD IN 3 7 63 1515 0 MAIN ELECTRICAL PARTS LIST NOTE: • Due to standardization, replacements in the • Items marked “*” are not stocked since they The components identified by mark 0 or dotted line with mark parts list may be different from the parts speci- are seldom required for routine service.
DVX-100 3 7 63 1515 0 Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark PARTS FOR INSTALLATION AND CONNECTIONS PARTS FOR INSTALLATION AND CONNECTIONS (for REMOTE CONTROL SENSOR) (for WIRELESS COMMANDER (RM-X120)) ************************************** ************************************** 1-476-924-11 SENSOR, REMOTE CONTROL...
Page 64
DVX-100 3 7 63 1515 0 Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark PARTS FOR INSTALLATION AND CONNECTIONS PARTS FOR INSTALLATION AND CONNECTIONS (for WIRED COMMANDER (RM-X130)) (for RF UNIT (HIDEAWAY)) ************************************** ************************************** not supplied...
Page 66
DVX-100 3 7 63 1515 0 REVISION HISTORY Clicking the version allows you to jump to the revised page. Also, clicking the version at the upper right on the revised page allows you to jump to the next revised page.
Need help?
Do you have a question about the DVX-100 and is the answer not in the manual?
Questions and answers