Removing And Attaching The Abs Panels - Ferno EZ-Glide 59T User Manual

7.10 Removing and Attaching
the ABS Panels
The molded ABS seat and back panels snap on and off the chair frame.
BACK PANEL
To remove the back panel: Gently pull downward on the flange near
one bottom corner and pull the corner of the panel away from the chair
(Figure 40). Repeat at the opposite corner. Then slide the panel up off
the two keepers at the top of the frame.
To attach the back panel: Orient the panel with the horizontal restraint
slots uppermost. Slide the two holes in the panel top flange down
over the keepers on the chair frame (Figure 41), then press both lower
corners of the panel against the sides of the frame until they snap into
place over the keepers.
SEAT PANEL
To remove the seat panel: Pull upward on the panel flange at each
front corner to pop the panel free of the seat frame (Figure 42) then lift
the panel off the chair.
To attach the seat panel: Align the panel with the chair frame and
press down to snap the panel onto the frame.
© Ferno-Washington, Inc. / 234-3298-07 / July 2018
Maintenance
Panel Keeper (2)
40
41
42
33