Removing And Attaching The Abs Panels - Ferno 59T EZ Glide User Manual

59T EZ Glide®
Maintenance
7.10 removing and attaching
the abs Panels
The molded ABS seat and back panels snap on and off the
chair frame.
baCk PanEl
To remove the back panel: Gently pull downward on
the flange near one bottom corner and pull the corner of
the panel away from the chair (Figure 36). Repeat at the
opposite corner. Then slide the panel up off the two keepers
at the top of the frame.
To attach the back panel: Orient the panel with the
horizontal restraint slots uppermost. Slide the two holes
in the panel top flange down over the keepers on the chair
frame (Figure 37), then press both lower corners of the panel
against the sides of the frame until they snap into place over
the keepers.
sEaT PanEl
Figure 36 - Releasing a Back Panel Bottom Corner
To remove the seat panel: Pull upward on the panel flange
at each front corner to pop the panel free of the seat frame
(Figure 38) then lift the panel off the chair.
To attach the seat panel: Align the panel with the chair
frame and press down to snap the panel onto the frame.
Panel Keeper (2)
Figure 37 - Back-Panel Keepers
Figure 38 - Releasing a Seat Panel Corner
28 © Ferno-Washington, Inc 234-3298-03 February 2013