Extending Lift Bar; Telescoping Lift Handles - Ferno EZ-Glide 59T User Manual

5.3 Extending Lift Bar

The rear operator uses the lift bar to guide and steer the chair when
rolling the chair and to control the chair on stairs.
The lift bar adjusts to five locked positions (Figure 11). Adjust the height
according to operator preference and the task or situation at hand.
RASING AND LOWERING THE LIFT BAR
1. Pinch and hold the release tabs together with one hand to unlock
the lift bar (Figure 12), then raise or lower the lift bar with the
other hand.
2. When the lift bar is near the desired position, let go of the release
tabs and raise or lower the lift bar until it locks into position.
3. Verify that the lift bar is locked by trying to raise or lower it without
squeezing the release tabs. When the lock is engaged the lift bar
will not move.

5.4 Telescoping Lift Handles

The telescoping lift handles adjust to five locked positions (Figure 11).
Adjust the handles according to operator preference and the task at hand.
EXTENDING/RETRACTING THE LIFT HANDLES
1. Press the release button (Figure 13) and push or pull the handle
near the desired stopping point.
2. Release the button and slide the handle a little forward or
backward until it locks into position.
3. Lock both handles at the same position. Verify that both handles
are locked by trying to push or pull them without pressing the
release buttons. When the locks are engaged, the handles will not
move.
16
Features
© Ferno-Washington, Inc. / 234-3298-07 / July 2018
Lift Bar
5 Locking Positions
Lift Handle
5 Locking Positions
11
12
13