Removing And Attaching The Abs Panels; Figure 41 - Releasing A Bottom Corner Of Backrest; Figure 42 - Lifting The Backrest Panel Over The Keepers; Figure 43 - Releasing A Corner Of The Seat Panel - Ferno EZ Glide 59-T Series User Manual

59, 59-T EZ Glide®
7.10 Removing and Attaching
the ABS Panels
The molded ABS seat and backrest panels snap on and off
the chair frame.
BACKREST PANEL
To remove the backrest panel: gently pull downward on
the flange near one bottom corner and pull the corner of
the panel away from the chair (Figure 41). Repeat at the
opposite corner. Then slide the panel up off the two keepers
at the top of the frame (Figure 42).
To attach the backrest panel: Orient the panel with the
horizontal restraint slots uppermost. Slide the two holes
in the top flange down over the keepers on the top of the
backrest frame, then press both lower corners of the panel
against the sides of the frame until they snap into place over
their keepers.
SEAT PANEL
To remove the seat panel: Pull upward on the panel flange
at each front corner to pop the panel free of the seat frame
(Figure 43) then lift the panel off the chair.
To attach the seat panel: Align the panel with the chair
frame and press down to snap the panel onto the frame.
© Ferno-Washington, Inc 234-3298-02 May 2009
Figure 41 - Releasing a Bottom Corner of the Backrest

Figure 42 - Lifting the Backrest Panel Over the Keepers

Figure 43 - Releasing a Corner of the Seat Panel

Maintenance
29