Key Access Programming - Paradox Esprit 738 Express+ Programming Manual

Note: Do not use the Intellizone feature and an entry delay for the same zone, otherwise an alarm may occur as a user
tries to disarm the system.

KEY ACCESS PROGRAMMING

Programs features quickly, without entering addresses or section numbers.
To activate "key access programming", press [
on the feature you wish to access - see below.) Press the key corresponding to the desired feature.
Press [ ] or [ ] to exit.
ENTER CLEAR
key
[8]
Installer test mode
In installer test mode, a confirmation beep (intermittent) indicates test is "on", a "rejection" beep (long) indicates
test is "off". The bell will squawk during walk testing to indicate opened, functional zones.
[9]
"Auto arming" time program
Key [9] flashes. Enter two digits (00 to 23) for hours + 2 digits (00 to 59) for minutes.
[ ]
"Panel time" and clear "trouble 8"
MEM
Key [ ] flashes. Enter two digits (00 to 23) for hours + 2 digits (00 to 59) for minutes.
MEM
[ ]
Test report
BYP
Reporting is enabled at address 086, keys [11], [12]. A value must be entered at address 512, and both telephone
and account numbers must be programmed.
[ ]
Call Espload via telephone
TRBL
Panel identifier and PC password (addresses 004-007) and computer telephone number (addresses 008-015) must
be programmed.
[ ]
Answer Espload
AWAY
This feature is available when using the ADP-1 adapter. In Espload, "blind dial" must be activated in "modem
setup" section, and panel phone number programmed (works also without ADP-1).
[ ]
Cancel communication attempts
STAY
Until next reportable event
When communicating with Espload, it is impossible to enter programming mode.
], followed by installer, master or user code 1. (Code required depends
ENTER
(installer code only)
(all 3 codes)
(all 3 codes)
(all 3 codes)
(all 3 codes)
(all 3 codes)
(master code and user 1 can only stop calls to Espload)
(installer code - all communications)
10