Snmp - Yamaha CS-700 Series Integrators Reference Manual

voip.noanswer- TEXT
forwarding-num
voip.noanswer- NUMBER
delay

7 SNMP

The CS-700 includes an SNMP agent that can be configured to provide SNMP support.
The table below describes the SNMP configuration settings that the CS-700 administrator must configure to enable
SNMP.
snmp-enable
snmp-address
snmp-community
snmp-contact-name
snmp-device-location
The following read-only properties and traps are supported.
Read-only Properties
• Serial number
• MAC address
• Base FW version
• USB connection active (0,1)
• USB microphone audio stream active (0,1)
• USB speaker audio stream active (0,1)
• USB video stream active (0,1)
Bluetooth connection active (0,1)
•
VoIP call active (0,1)
•
Yamaha CS-700 Integrators Reference Guide
VoIP dialing number.
2..30 : Seconds to
wait before
forwarding a call
Enable or disable SNMP support. Disabled (0) means that SNMP is not
supported. Enabled (1) means that SNMP is available.
Specifies SNMP server address to which traps will be sent. Leave blank to
disable traps.
Specifies the SNMP read-only community string used for queries from the
server and transmitted traps. Read-only indicates the authorization level.
The device does not support write operations initiated through SNMP.
Specifies the contact name, typically the system administrator. This string
is informational and can include an email address. It is not associated with
traps.
Specifies the location of the device for informational purposes.
Forward incoming VoIP
calls to the specified
number if the call is not
answered within the
duration specified in the
'noanswer-delay' attribute.
10 Number of seconds to wait
before forwarding an
unanswered incoming call
to the 'noanswer-
forwarding-num' number.
158