Comments; Emc Directive; Low Voltage Directive (Safety) - Fluke 3125 User Manual

3125 Detachable Hotplate
User's Guide
4.2
4.2.1
4.2.2
12
Problem Possible Causes and Solutions
The display shows any Controller problem. The error messages signify the following problems with
of the following: err 1,
the controller.
err 2, err 3, err Err 1 - a RAM error
4, Err 5, Err 6, or
Err 2 - a NVRAM error
Err 7
Err 3 - a Structure error
Err 4 - an ADC setup error
Err 5 - an ADC ready error
Err 6 – a defective control sensor
Err 7 – a heater error
Initialize the system by performing the Factory Reset Sequence describe
above.
Temperature cannot be Incorrect High Limit parameter. The High Limit parameter may be set below
set above a certain point
400°C. Check this value as described in the 2200 User's Guide.

Comments

EMC Directive

Hart Scientifics' equipment has been tested to meet the European Electromag-
netic Compatibility Directive (EMC Directive, 89/336/EEC). The Declaration
of Conformity for your instrument lists the specific standards to which the unit
was tested.

Low Voltage Directive (Safety)

In order to comply with the European Low Voltage Directive (73/23/EEC),
Hart Scientific equipment has been designed to meet the IEC 1010-1 (EN
61010-1) and the IEC 1010-2-010 (EN 61010-2-010) standards.