Table of Contents
Advertisement
Flush-fit installation
Flush-fit installation is only possible in
natural stone (granite, marble), solid
wood and tiled worktops. Certain
models are suitable for building into
glass worktops - please see relevant
label on the hob. When using a
worktop made from any other
material, please check first with the
worktop manufacturer that it is
suitable for installing a flush fit hob.
The internal width of the base unit
underneath the appliance must be at
least as wide as the inner worktop cut-
out (see "Building-in dimensions -
flush fit"), so that the hob is easily
accessible from underneath after
installation and the bottom half of the
casing can be removed for
maintenance. If the underside of the
hob is not freely accessible after
installation, any sealant used to plug
the gaps around the appliance must
be removed to enable the hob to be
lifted out of the cut-out should this be
necessary.
Installation notes
Natural stone worktops
The hob is set directly in the cut-out.
Solid wood worktops, tiled worktops,
glass worktops
The hob is set on a wooden frame
inside the cut-out. The frame must be
provided on site, and is not supplied
with the appliance.
57
Hide quick links:
Advertisement
Table of Contents
