Advertisement
3.
Using the mounting template or the mounting base, mark the holes for the camera mounting
screws.
4.
Drill holes for the screws that anchor the base to the mounting surface. The mounting hardware
provided is appropriate for most surfaces. However, depending on the surface material and strength,
more appropriate fasteners may be required.
5.
Drill a 3/4" hole through the mounting surface for the drop cable, if necessary.
6.
If using wall inserts for the mounting screws, install the wall inserts at this time.
7.
Attach the mounting base the surface using the appropriate fasteners. If the camera drop cable will
route through a cable guide, lay the cable in the guide before tightening the mounting screws.
8.
If the drop cable will route through a hole in the mounting surface, route the cable through the hole,
and then reassemble the camera on the mounting base. Thread the bezel onto the mounting base
only enough to hold the assembly together. Do not tighten the bezel.
9.
Route extension cables from the power source and DVR to the mounting location.
10.
Connect the network video coax and power extension cables to the camera drop cables.
Drop cable connectors are not waterproof.
due to moisture or another contaminant is considered an installation error, which
!
voids the warranty. If installing this camera in a location such as an overhang, shop,
WARNING
garage, kitchen, etc. where high humidity or dust is present, seal these connections
adequately.
12.
Apply power to the camera through the 12 Vdc power cable.
Camera adjustments
1.
While observing video from the camera, move the camera module to adjust direction, tilt and
horizontal alignment to center the field of view on your surveillance target. Loosen the bezel if
needed to so the camera module can be adjusted easily.
2.
While holding the camera module and enclosure in place, tighten the bezel to lock the camera in
position.
Camera configuration customization
For configuration and customization, refer to the User Manual for your camera or recorder.
2
www.observint.com
Failure of the power or video connector
Specifications
Camera Model (SKU).
T5
Image Sensor
1/2.7" CMOS
Resolution
5MP: 2592 (H) × 1944 (V)
Video Output Termination
1-channel BNC video output
Minimum Illumination
0.05 lux @ F1.0 (AGC ON)
0 lux with IR ON
IR Cut Filter
Yes, 850 nm
DWDR
Yes
WDR
N/A
IR LEDs
18
Night Vision (IR range)
65 ft (20 m)
Lens
2.8 mm
Viewing Angle (degrees)
Horizontal FOV: 102.94°
Backlight Compensation
Off (default)
Mechanical Zoom
Fixed focus
Audio - Microphone
No
Audio Range (Mtrs)
N/A
On-screen display (OSD)
Yes
Operating Power
4 W max.
Operating Temperature
-22° ~ +131°F (-30° ~ +55° C)
Number of PIRs (motion detection)
1
PIR Detection Angle
120°
PIR Detection Distance
23 ft (7 m)
Cleaning
Clean the camera dome with an approved glass cleaning solution and a lint free cloth.
Dust can be removed from the unit by wiping it with a soft damp cloth. To remove stains, gently rub
•
the surface with a soft cloth moistened with a mild detergent solution, then rinse and dry it with a
soft cloth. Do not use benzene, thinner or other chemical products on the camera assembly; these
may dissolve the paint and promote damage of the surfaces.
Remove all foreign particles, such as plastic or rubber materials, attached to the camera housing.
•
These may cause damage to the surface over time.
© 2018 Observint Technologies. All rights reserved.
Advertisement
