Factory Reset Procedure; Manual Configuration Of The Wireless Phone - SpectraLink Quick Network Connect User Manual

S P E C T R A L I N K Q U I C K N E T W O R K C O N N E C T ( Q N C ) G U I D E
Now, the wireless data that QNC has will need to be transferred (downloaded) to the phone. The transfer of data
is done using a USB cable which comes with the QNC device. (You can connect up to 4 phones at a time using the
4 USB ports, provided you have four connecting cables.) In order to download the wireless configuration from the
QNC, the phone must be done in a FACTORY RESET mode. Normally, a brand new phone is already factory reset.
Factory reset procedure (if needed):
• Go to the phone menu:
• Settings ► Advanced Settings ►
• Password: 456 (the default password is 456 unless it was changed by someone).
• Administration Settings ► Reset to Defaults ► Reset to Factory ► Yes
The factory reset phone needs to be connected with the QNC with the USB cable. As you connect the phone with
the QNC, the phone will make a peculiar sound, and starts rebooting. You should see the phone rebooting within
15 seconds. At this point, you will no longer need to keep the phone connected to the QNC. Even if you keep the
phone connected, it will not matter. (Also, when you start factory resetting the phone should not matter while it is
connected to the QNC).
If the phone does not reboot, you may need to manually update configuration as follows:
• Go to the phone menu:
• Settings ► Basic Settings ► Update Configuration
The phone should now start rebooting.
As the phone reboots, it will take the wireless information, and the phone will get an IP address. To check if the
phone gets the IP address:
• Go to the phone menu:
• Settings ► Status ► Network ► TCP/IP Parameters
There you will see the IP address, subnet mask, and the default gateway per your wireless network configuration.
Again, the main purpose of this QNC guide is to enable the phone to acquire the IP address from the wireless
network.
Manual Configuration of the Wireless Phone (without the QNC)
Except for loading certificate (if necessary), you can configure/edit the phone's wireless settings manually – without
using the QNC – albeit this could be cumbersome for some. In the phone, we can navigate to the following:
Settings ► Advanced Settings ► Administration ► Network Configuration ► Network Interfaces ► Wi-Fi Menu
If not, there could be some issue.
6