Troubleshooting - Bissell 2069H User Manual

Troubleshooting

Problem Possible causes
Formula Tank empty
Reduced
Lint screen on Formula Tank
spray OR
cap clogged
no spray
in upright
mode
Upper body not attached prop-
erly.
Formula Tank empty
Spray nozzle clogged
Reduced
Pump needs priming
spray or
no spray
attachment
Machine is reclined
ReadyTools dial is set to "FLOOR
CLEANING"
Dirty Water Tank not aligned/
secured
Dirty Water Tank full
Removable nozzle installed
improperly
Machine
not picking
Removable nozzle full of debris
up cleaning
formula
Red lint screen under Dirty Water
Tank clogged
ReadyTools dial not set properly
Handle not reclined.
Brush not
turning
WARNING
To reduce the risk of electric shock, push power button
OFF and disconnect plug from electrical outlet before
performing maintenance or troubleshooting checks.
Remedies
Refill tank with water and formula.
Soak Formula Tank cap in warm
water and then rinse under running
water.
Repeat steps 1-4 on page 5.
Refill tank with water and formula.
Clean spray nozzle by rinsing tool
under water.
Place tool on floor and press spray
trigger.
Return machine to full upright
position until it locks into place.
Choose "TOOLS" setting on
ReadyTools dial.
Check tank alignment and secure
with side latches.
Empty tank.
Unplug unit. Align four "hooks" into
bottom first, then snap into place
on top.
Unplug unit. Remove nozzle and
rinse under running water.
Remove debris from lint screen.
Choose either "FLOOR CLEANING"
or "TOOLS" for desired cleaning
method.
Press the red recline lever on the
back of the unit to activate the
brush. Follow step 4 under "Carpet
Cleaning" on page 7.
www.BISSELL.com.au
11