Prior To Operation - ATD Tools ATD-7343 Owner's Manual

WARNING:
Ensure that there are no persons inside the vehicle to be li ed. Switch o the engine and apply the brake.
Chock each unli ed e in BOTH direc ons as shown below.
WARNING:
Posi on the jack under the manufacturer's recommended li ing point for the vehicle. O centered loads
can slip and accidents may result.
WARNING:
During raising and lowering of the load, precau ons should be taken to avoid movement of the vehicle.
WARNING:
Tra c may cause the raised vehicle to rock during roadside use of the jack.
WARNING:
Never work on, under or around a raised vehicle supported only by a hydraulic jack. Always use
adequately rated jack stands.
WARNING:
Never posi on any part of your body near the movable parts of the jack.
WARNING:
Ensure that there are no persons, tools or obstruc ons underneath the vehicle prior to lowering.
WARNING:
Do not adjust the overload bypass valve under any circumstance.

PRIOR TO OPERATION:

Air may become trapped in the hydraulic system during transit.
To Purge Air
1. Insert the handle into the socket and secure it with the set screw provided.
2. Turn the handle counterclockwise un l release valve is open; pump the jack several mes to purge the accumulated
air in the system.
3. Turn the handle clockwise to close the release valve. The jack is now ready to use.
OPERATING INSTRUCTIONS:
To Lift a Vehicle:
Turn the handle clockwise. Move the handle up and down. Use the full stroke of the piston for greater speed.