Describing Installer-Set Id Numbers For Bus Devices - Risco ProSYS Plus Quick Installer's Manual

Describing Installer-Set ID Numbers for Bus Devices

For each bus device category (see table below), each of its respective bus devices
gets a sequentially-assigned, installer-set "physical" ID number that the installer
physically sets with the device's DIP switches before powering up the device.
NOTE: To be unique, bus devices in the same category that are on the same bus
line must have sequentially different physical ID numbers, whereas different
devices (or the same bus device types on different bus lines) can have the same
physical ID number.
Categories
ZONES
OUTPUTS
POWER SUPPLY
UNITS
WIRED KEYPADS
BUS SOUNDERS
KEY READERS
09/2016
Respective bus devices
Bus Zone Expanders
Bus zones (bus detectors)
Zone expansion modules: Single-Zone Expander, 8-Zone
Expander, 16-Zone Expander
Wireless Expander
Output expansion modules: (4 outputs/3A, 8 outputs/100 mA)
Power supply expansion modules: 1.5A, 3A
Elegant, PS LCD, LS LCD
ProSound, Lumin8
Proximity Key Reader
Page 18 5IN2371 C