Advertisement
3. If the flushing begins to weaken, or if the nozzle spray
seems to be getting weaker, clean the filters.
(1) Turn the water shut-off valve clockwise to close it.
As the water shut-off valve is pre-adjusted, keep track
of the turns so that you can return to the original
position.
(2) Remove the filter located on the left side of the SpaLet
seat unit.
Place a wash bowl or similar item underneath the Filter.
(3) Rinse the filter.
(4) Firmly tighten the filter.
(5) Open the water shut-off valve by turning it back to its
original position.
4. If freezing weather is anticipated, drain the water.
(1) Close the water shut-off valve to shut-off the water
supply.
* If the open/close knob is difficult to turn, grasp it with a dry cloth
and turn.
(2) Move the flush lever to drain water from the toilet tank.
(3) Drain the water from the water supply side.
Place a basin or similar beneath the strainer.
‚ Remove the strainer, rinse away dirt that has attached to the
strainer and O-ring, and then completely remove the part.
ƒ Insert the power plug into an outlet.
„ Press and hold both the [Massage] and [Nozzle Position
buttons for at least 2 seconds.
* Remaining water in the toilet body will drain over a 15-second
period.
… Disconnect the power plug from the outlet.
† After the water has been drained, securely reattach the strainer.
(4) Check for leaks from the water shut-off valve.
-18 - EN-
®
Turn
counterclockwise
Lock Lever
Lock Lever
]
Turn
counterclockwise
[Massage] + [Nozzle Position
mark of the mounting plate
mark of the mounting plate
Convex part of the
Convex part of the
Turn
clockwise
back of the seat unit
back of the seat unit
Tighten until the end surface
of the strainer is flush with
the socket end surface.
Water
Water
Valve
Valve
Turn
Turn
clockwise
clockwise
Filter
Filter
Water
Water
Valve
Valve
Turn
counterclockwise
Strainer
Water supply
socket
Filter
Filter
Flat-blade
screwdriver
]
Advertisement
