Display Isis Interface - H3C S9500 Series Command Manual

Command Manual – ISIS
H3C S9500 Series Routing Switches
IS-IS Level-1 Restart Status
Restart interval: 100s
SA bit supported
Total Number of Interfaces: 6
Restart Status: RESTART COMPLETED
IS-IS Level-2 Restart Status
Restart interval: 100s
SA bit supported
Total Number of Interfaces: 7
Restart Status: RESTART COMPLETED

1.1.6 display isis interface

Syntax
display isis interface [ interface-type interface-number ] [ verbose ]
View
Any view
Parameters
interface-type interface-number: Interface type and interface number.
verbose: Displays detailed information about interface.
Description
Use the display isis interface command to display information about IS-IS-enabled
interfaces.
The display isis interface command displays the following information about
IS-IS-enabled interfaces: interface name, interface IP address, link state of the
interface, and so on. Besides these information, the display isis interface verbose
command also displays IS-IS parameter settings on interface, such as CSNP
broadcast interval, Hello broadcast interval and number of invalid Hello packets.
Use the display isis interface interface-type interface-number command to display
IS-IS information about a specified interface.
Examples
# Display IS-IS information about VLAN-interface 1.
<H3C> display isis interface vlan-interface 1
Interface
Vlan-interface1 172.16.1.2
# Display detailed IS-IS information about VLAN-interface 1.
IP Address Id
001
1-6
Chapter 1 IS-IS Configuration Commands
Link.Sta IP.Sta
Down Down 1497
MTU Type DIS
L12 No/No