H3C S9500 Series Command Manual page 381

Command Manual – RPR
H3C S9500 Series Routing Switches
Description
Use the port-type command to set the 10G RPR board mode. After the mode changes
successfully, the board restarts automatically for the port to switch to new RPR port
type.
Caution:
This command is only available to 10G RPR ports. A 2.5G RPR port supports only
the POS mode, and a GE RPR port supports only the RprGE mode.
After you change the port type of an RPR port and the card restarts, the existing
configuration of the port will be automatically removed. Therefore, you need to
configure the port again.
Examples
# Set RPR port type to 10GE.
<H3C> system-view
[H3C] interface RprPos 3/1/1
[H3C-RprPos3/1/1] port-type 10ge
1.1.19 reset counters interface
Syntax
reset counters interface [ interface-type interface-number ]
View
User view
Parameters
interface-type: Interface type.
interface-number: Port number, in the format of slot number/card number/port number.
The port can be an RPRPOS logical interface or physical port.
Description
Use the reset counters interface command to clear port statistics to implement
statistics of related information on the port..
Examples
# Clear the statistics on RPRPOS 2/1/1.
Chapter 1 RPR Port Configuration Commands
1-29