Display Ip Routing-Table Ip-Address1 Ip-Address2 - H3C S9500 Series Command Manual

Command Manual – Static Route
H3C S9500 Series Routing Switches
# There are no corresponding routes in the natural mask range (only displaying the
longest matched route). Display the detailed information.
<H3C> display ip routing-table 169.168.1.2 verbose
Routing tables:
Generate Default: no
+ = Active Route, - = Last Active, # = Both
Summary count: 1
**Destination: 192.168.1.0
For detailed description of the output information, see

1.1.4 display ip routing-table ip-address1 ip-address2

Syntax
display ip routing-table ip-address1 mask1 ip-address2 mask2 [ verbose ]
View
Any view
Parameters
ip-address1, ip-address2: Destination IP address in dotted decimal notation.
ip-address1, mask1, mask2 and ip-address2 determine one address range together.
ANDing ip-address1 with mask1 specifies the start of the range while ANDing
ip-address2 with mask2 specifies the end. This command is used to display the routes
in this address range.
mask1, mask2: IP address mask, length in dotted decimal notation or integer form. It
ranges from 0 to 32 when it is presented in integer.
verbose: With the verbose keyword, this command displays the verbose information
of both the active and inactive routes. Without the parameter, this command only
displays the summary of Active routes.
Protocol: #STATIC
*NextHop: 192.168.1.2
Vlinkindex: 0
State: <Int ActiveU Gateway Static Unicast>
Age: 4:39 Cost: 0/0
Protocol: #DIRECT
*NextHop: 192.168.1.1
Vlinkindex: 0
State: <Int ActiveU Retain Unicast>
Age: 12:51 Cost: 0/0
Chapter 1 Static Route Configuration Commands
Preference: 60
Interface: 192.168.1.1(Vlan-interface10)
Tag: 0
Mask: 255.255.255.0
Preference: 0
Interface: 192.168.1.1(Vlan-interface10)
Tag: 0
Table
1-7
* = Next hop in use
1-2.